1 - Remove the plasc piece that says IPS by taking out the two push pins:
2 - Carefully remove the yellow coupler from the gun without damaging the plasc threads. Wrap the male threads of the yellow coupler with 2 wraps of thread tape :
3 - Carefully screw the Female Quick Connect coupler into the gun, and the male Quick Connector on to the yellow coupler as shown. Be careful that you don’t cross-thread or over ghten the ﬁ0ngs and damage them.
4 - If you screw in the quick connect too far, it might crack the end of the wand. If that happens, just cut oﬀ 12” of the plasc wand with a hacksaw and start over, or use a tap and die set to re-thread the inside of the wand. Heang up the end of the plasc makes it easier to install the quick connect.
We also offer two different options that improve the performance and ease of use for contractors that value speed and better performance.
Our Quick Connect Upgrade Kit for $16.99 gives you all the Quick Connect fittings and parts that you need to setup your gun for using the same Quick Connect fittings and tips that you use every day. It also makes it faster and easier to change out tips on the fly!
The 29500-QC Kit Includes:
1-- 1/4" 40 Degree Nozzle
1-- 1/4" 0 Degree Nozzle
1 --1/4" QC Socket
1-- 1/4" QC FPT
Our Wood Pro Upgrade Kit for $29.99 includes everything in the QC Kit, and actually increases the guns performance allowing you to use it for applying thicker and heavier wood stains, like Ready Seal Deck Sealer and even Armstrong Clark Semi Transparent Stains! Most pump up sprayers have a hard time applying these products because they contain a lot heavier pigments for better UV Protection.
The 29500-WP Kit Includes:
20' section of larger diameter Heavy Duty chemical resistant PVC Tubing.